Delta AC Mini Plus -7 kW

The Delta AC Mini charging station is equipped with either a universal type 2 sockets or a tethered EV cable of type 2. Perfect for office and commercial use.

  • Charging Speed – 7 kW (40 kilometers per hour of charge)
  • OCPP 1.5 & 1.6 (open charge point protocol)
  • RFID
  • Compatible with all-electric vehicles and models including: Audi, BMW, BYD, EQC, Holden, Honda, Hyundai, Jaguar, KIA, Mazda, Mercedes Benz, Mini, MG, Mitsubishi, Nissan, Polestar, Porsche, Renault, Rivian, TESLA, Toyota, Volkswagen, Volvo

Depending on the car, the Delta AC Mini Universal Charger will require a detachable cable- either a Type 1 or Type 2 EV cable.

Type 1
Audi (pre-2018), BMW (pre-2018), Holden Volt, Mercedes Benz (pre-2018), Mitsubishi Outlander PHEV, Nissan Leaf (2012-2017), Volvo (pre 2019).

Type 2
Audi (2019+), BMW (2018+), BYD, EQC, Holden, Honda, Hyundai, Jaguar, KIA, Mazda, Mercedes Benz (2019+), Mini, Mitsubishi, Nissan (2019+), Polestar, Renault, Rivian, TESLA, Toyota, Volkswagen, Volvo (2019+).

Features

  • 7 KW, 32Amp, Single Phase Configurable Power
  • OCPP 1.5 & 1.6 (open charge point protocol)
  • The motorist brings their own EV charging cable or there is a hardwired 5m Type 2 version available that is suitable for charging all electric vehicles in Australia.
  • The IP55 and IK08 enclosures are suitable for both interior and outdoor environments.
  • Wall-mounted
  • CE and RCM mark
  • Compliant with IEC 61851-1, IEC 61851-22
  • Internal RCD 30mA RCD and DC 6mA RCD
  • Operating temperature -30C to +50C 318*363*130mm
  • Height: 318 mm, Width: 363 mm, Depth: 130 mm
  • Electrical Protection : Over current, Over Voltage, Under Voltage, Residual Current, Surge Protection, Short Circuit, Over temp, Ground Fault, Plug-Out Protection
  • Network Interface 3G, WLAN, Ethernet
  • RFID
  • Made in Taiwan
  • EV Dynamic Load Management is available but requires additional modules and extensive integration
  • USB stick firmware upgrades for the AC Mini Plus
  • Variable current output at installation via internal dipswitches that permit the charger to limit the amount of required current
  • Multi-communication options for back-end integration
  • Network Interface 3G, WLAN, Ethernet
Power Output7 KW, 32Amp
Mount TypeWall-mounted
Electrical ProtectionOver current, Over Voltage, Under Voltage, Residual Current, Surge Protection, Short Circuit, Over temp, Ground Fault, Plug-Out Protection
Dimension(H x W x D)318 x 363 x 130mm